However, an important step is to put the load on the tray. You need to know the load position on the tray is important. More than the side of the tray or more than 4 inches of interior is the load should not be done, the tray itself has the rules, the state of the tray should always be good.
When stretching the packaging, don’t skip the steps to protect the tray. When we wrap the load, the load package pallet is a choice. However, this can happen in the case of a forklift or a pallet. When the puncture occurs, the opportunity to puncture the puncture is introduced and the loss of the containment forces is generated. The risk of load failure has also been increased.
That’s one of the reasons we invented the pallet grip. The bottom inches of the film will automatically become a roll, and in general they will roll into a taut cable. The cable was pushed to the deck under the top of the tray. Because you need to leave enough space to clean the fork, this is to avoid the problem of puncture. At the same time, they are still close enough that it is possible to lock the load on a tray.
However, we all know that it is not possible to prevent load transfer in transit, even with the use of pallet grip or other fixed measures to stretch the packaging process. Do you know what the connection load is? It can hold the bottom of the load and the pallet connection. But the top and middle loads can still move from the lead. However, the risk of load sliding on the pallet can be reduced by the load key.